Hydropool Hot Tub Owner's Manual page 32

SETTING FIRST FILTER CYCLE DURATION
1 Press Program key a third time.
2 The display will show d1xx, with "xx" representing
the duration in hours.
3 Use Up and Down arrows to change setting.
SETTING SECOND FILTER CYCLE START TIME
1 Press Program key a fourth time.
2 The display will show S2xx, with "xx" representing
the starting hour.
3 Use Up and Down arrows to change setting.
SETTING SECOND FILTER CYCLE DURATION
1 Press Program key a fifth time.
2 The display will show d2xx, with "xx" representing
the duration in hours.
3 Use Up and Down arrows to change setting.
* If no filtering is required, the duration should be set to "0".
For continuous filtering, the filter cycle duration should be
set to "12.00".
3 – WATER TEMPERATURE DISPLAY UNIT
Water temperature can be displayed in either Fahrenheit
(°F) or Celsius (°C).
TO DISPLAY THE TEMPERATURE UNIT
1 Press Program key a sixth time.
2 The display will show TU x, with "x" for either
°F or °C.
3 Use Up and Down arrows to change setting.
4 – STORE SETTINGS & EXIT PROGRAMMING
Press Program key a seventh time to store settings in system
memory and to return to normal operation.
H y d r O p O O l I n d u s t r I e s
PURGE CYCLE
The system will automatically activate P2, P3 & Blower for
30 seconds at the beginning of every filter cycle.
MODE FUNCTION
ECONOMY MODE
The hot tub will heat only during the filter cycles.
STANDARD MODE
The preset hot tub temperature will be maintained (the
system will automatically activate P1 low speed when the
control calls for heat).
LCD DISPLAY
INvERTING THE DISPLAY
Pressing and holding Light key for 5 seconds will invert the
display allowing it to be read from inside or outside the spa.
To return to non-inverted mode, simply press and hold Light
key again for 5 seconds.
3
This key is used to change hot tub operation to
either ECONOMY or STANDARD mode.
The display toggles every 5
seconds alternately showing the
time and the current water
temperature.