Hydropool Hot Tub Owner's Manual page 20

PUMP / JETS FUNCTION
- press this pad to activate the pump
1st press – turns on low speed
2nd press – turns on high speed
3rd press – turns off pump
When low speed is already operating, the 1st press of the
pad puts the pump directly into high speed.
Low speed starts automatically every 30 minutes to measure
water temperature (in STANDARD Mode only – see MODE
FUNCTION), when a filter cycle is activated, or when a
freeze condition is detected.
When the blower (optional) is manually activated, the pump
low speed is automatically activated and operates until the
blower times out. If the blower is turned on even briefly,
and then turned back off, low speed will operate for a
minimum of 2 minutes.
PUMP AUTOMATIC TIME-OUT
High speed – 15 minutes
Low speed – 2 hours
CLEAN-UP CYCLES
The Clean-up Cycle begins 30 minutes after the pump
or blower have been turned off or have automatically
timed-out. The pump low speed and the ozonator (optional)
will operate for one hour.
FILTER CYCLES
The system will automatically activate the pump low speed
to filter the water either once or twice each day, and can be
programmed by the user. The first filter cycle ("day") begins
6 minutes after the spa is initially powered up. The second
filter cycle ("night") begins 12 hours after the start of the
first filter cycle. The filter cycle duration - length of time
the pump low runs - is programmable from 1 to 12 hours
(F1 to F12). The factory default is 2 hours, twice daily.
PROGRAMMING FILTER CYCLES
To change the factory default filter cycle settings
Press then - the current filter cycle duration will
be displayed
Press again to adjust the filter cycle duration
Press to configure the filter cycle frequency
H y d r O p O O l I n d u s t r I e s
The display will show:
Press
For continuous filtration, select F12 and
Press
MODE FUNCTION
A combination of keypads is used to change hot tub
operation to either 'STANDARD', 'ECONOMY' or 'SLEEP' mode.
PROGRAMMING MODE FUNCTION
Press
the display
Press
Press
STANDARD MODE
The system automatically starts the pump low speed every
30 minutes to measure water temperature, and maintain
the set temperature. The display will show
then the last measured water temperature. The current
water temperature is displayed only after the pump has
been operating for at least 2 minutes.
ECONOMY MODE
The system will heat to the set temperature only
during the filter cycles. The display will show
the temperature is non-current. When the temperature is
current, the display will alternate between
water temperature.
STANDARD-IN-ECONOMY MODE
While the system is in Economy Mode, pressing the
pad or the
activate Standard Mode for 1 hour, after which the system
will revert back to Economy Mode. The display will show
during this time will put the system back into Economy
Mode immediately.
SLEEP MODE
The system will heat to within 20˚F of the set temperature
only during filter cycles. The display will show
mode is changed.
0
both day and night cycles
day cycle only
night cycle only
to select the number of filter cycles
to exit programming mode and save changes.
then - the current mode setting will flash on
to cycle though to the desired mode
to select and confirm the selection.
or pad will cause the system to
while in this mode. Pressing the
briefly,
when
and the
then pads
until the