Hydropool Hot Tub Owner's Manual page 36

PURGE CYCLES
The system automatically activates P2 & P3 for 10 minutes,
and the blower for 30 seconds at the beginning of each
filter cycle to introduce fresh, sanitized water into these
plumbing circuits.
MODE FUNCTION
This pad is used to change hot tub operation to either
STANDARD, ECONOMY or SLEEP mode.
STANDARD MODE
The system automatically starts P1 low speed every 30
minutes to measure water temperature, and maintain the
set temperature. The display will show STD for 3 seconds,
and then the word STANDARD will remain on the display
along with the last measured temperature.
ECONOMY MODE
The system will heat to the set temperature only during
the filter cycles. The display will show ECN and the word
ECONOMY.
SLEEP MODE
The system will heat to within 11˚C of the set temperature
only during filter cycles. The display will show SLP.
LIQUID CRYSTAL DISPLAY (LCD)
Continually provides feedback on the
operating status of the hot tub.
Icons indicate various functions and
programming information.
LCD INvERT
This feature inverts the LCD readout for convenient viewing
from inside the hot tub.
To invert the readout,
press or then
To return the LCD readout to normal viewing (from outside
of the hot tub), repeat this sequence.
H y d r O p O O l I n d u s t r I e s
TOPSIDE PANEL LOCK FEATURES
TEMPERATURE LOCK
The temperature lock feature prevents unauthorized
temperature adjustment of the hot tub water. When the
temperature lock is activated, all automatic functions will
continue to operate normally.
When locked, the display will show the water temperature,
and the word SET. The temperature pads will be
deactivated, and when pressed, the display will show the set
temperature with a double arrow next to it.
The following pads must be pressed within 3 seconds of
each other to activate the lock:
then
TOPSIDE PANEL FULL LOCK
The topside panel lock feature prevents unauthorized use
of the hot tub controls. When the topside control panel
lock is activated, all automatic functions will continue to
operate normally.
When locked the display will show the water temperature
as well as
deactivated.
The following pads must be pressed within 3 seconds of
each other to activate the lock:
then
TOPSIDE PANEL UNLOCK
The following pads must be pressed within 3 seconds of
each other to deactivate the lock:
then
36
then then
. All of the topside control panel pads will be
then
then