Hydropool Hot Tub Owner's Manual page 30

LIQUID CRYSTAL DISPLAY (LCD)
... C ontinually.
operating. status. of. the. hot. tub..
Icons.indicate.various.functions.
and.programming.information.
LCD INvERT
This feature allows you to invert the LCD readout for
convenient viewing from inside the hot tub. All other
functions will continue to operate normally. The following
pads must be pressed within 2 seconds of each other.
To invert the readout,
Press Then
To return the LCD readout to normal viewing (from outside
of the hot tub), repeat the above sequence.
TOPSIDE PANEL LOCK FEATURES
TEMPERATURE LOCK
The temperature lock feature prevents unauthorized
temperature adjustment of the hot tub water. When the
temperature lock is activated, all automatic functions will
continue to operate normally.
The following pads must be pressed within 3 seconds of
each other to activate the lock:
then then then
TOPSIDE PANEL FULL LOCK
The topside panel lock feature prevents unauthorized use
of the hot tub controls. When the topside control panel
lock is activated, all automatic functions will continue to
operate normally.
The following pads must be pressed within 3 seconds of
each other to activate the lock:
then then
TOPSIDE PANEL UNLOCK
The following pads must be pressed within 3 seconds of
each other to deactivate the lock:
then P1 then
H y d r O p O O l I n d u s t r I e s
STANDbY/DRAIN ASSIST
displays. the. .
The standby/drain assist feature stops the system from
operating automatically, allowing for convenient filter
cartridge removal or for safe draining of the hot tub. The
following pads must be pressed within 2 seconds of each
other. To put the system in standby,
Press
All functions will turn off, but P1 low speed can be
activated (by pressing the 'jets' pad) to facilitate draining
the hot tub. Press any pad other than the 'jets' pad to return
the system to normal operation. See DRAINING YOUR HOT
TUB - p. 47 for detailed instructions.
MOOD LIGHTING
STANDARD MOOD LIGHTING
Press the
on and off.
LED MOOD LIGHTING
Press the
selection of LED lighting modes. Pressing the
on/off within 3 seconds cycles through the various 'light
shows' . When the LED lighting is turned off for more than 5
seconds, then turned back on, the system will resume the
last 'light show' . For complete description of 'light shows',
see MOOD LIGHTING – p. 14
The system will automatically turn off the mood lighting
after 4 hours.
bLOWER
Press this pad to turn the blower on and off. The system will
automatically turn off the blower after 15 minutes.
OzONATOR
The ozonator operates during FILTER CYCLES and CLEAN-UP
CYCLE only (starts 2 minutes after filter cycle begins).
FREEzE PROTECTION
If the temperature sensor detects a drop to 44˚F within
the heater chamber, the system automatically activates all
pumps to provide freeze protection. The pumps will operate
until the temperature reaches 45˚F, and then will continue
to operate for an additional 4 minutes before returning to
normal system mode.
30
Then
pad on the topside control to turn the light
OPTIONAL – FACTORY INSTALLED
pad on the topside control to pstart the
OPTIONAL - FACTORY INSTALLED
OPTIONAL
pad