Mspa-Mp.digital.control - Hydropool Hot Tub Owner's Manual

INITIAL START-UP
When you initially power up your hot tub, it will default
to the factory-preset temperature of 100˚F (38˚C), and
filtration cycle of 3 out of every 12 hours (see PRESET
1
FILTER CYCLES). Anytime power to your hot tub is
interrupted the system will default to these settings.
TEMPERATURE ADJUSTMENT
Use these
or decrease water temperature. The
temperature setting will be displayed for
5 seconds to confirm your new selection.
Note: The "Set Point" symbol indicates the desired
temperature, NOT the current water temperature!
Water temperature can be adjusted by 1° increments from
15 to 40°C.
PUMPS/JETS FUNCTION
Press P1 key to turn on P1 low speed.
Pressing a second time turns P1 to high
speed. The third press turns P1 off.
STARTING P2 OR P3
Press P2 or P3 key to turn on pump. Pressing a second time
turns off pump.
AUTOMATIC TIME-OUTS
P1, P2, P3 high speed - 15 minutes
P1 low speed - 4 hours
CLEAN-UP CYCLE
After P1 high speed is turned off either manually or
automatically, P1 low speed circulates the water for 1
hour.
H y d r O p O O l
spA COntrOl systeM – eurOpe
tItAnIuM serIes COntrOl – I
SYSTEM CONTROL MSPA-MP, TOPSIDE PANEL TSC-4
arrows to increase
I n d u s t r I e s
economy Mode Icon
Heater Icon
Filter Icon
program Icon
SYSTEM PROGRAMMING...
1 Enter Programming mode by pressing down &
holding Program key for 3 sec. Then proceed
through the following 4 steps:
1 – SYSTEM CLOCK TIME
Setting the time:
The display will show the current setting.
Use Up and Down arrows to change setting.
2 – FILTER CYCLE START TIME AND DURATION
The system automatically performs two filter cycles per day.
To program a filter cycle, you must enter: 1) the time you
want the cycle to start and 2) the duration of the cycle.*
SETTING FIRST FILTER CYCLE START TIME
1 Press Program key a second time.
2 The display will show S1xx, with "xx"representing
the starting hour.
3 Use Up and Down arrows to change setting.
31
Mode Key
program Key
lock Icon
temperature value