Westerbeke 7.0 KW BGC -60Hz Technical Manual page 94

6. Remove the remaining three cover screws and their washers. Lift the carburetor's top cover straight up
and away from the carburetor's base.
7. In the carburetor top cover, gently punch out the float retaining pin in the opposite direction of the split
side of the pivot bracket and remove the float. Make sure you catch the needle valve that hangs from
the float retaining hook under the float's pivot arm and place
it
aside.
8. Remove all of the old cover gasket from both halves of the carburetor.
9. Shake the float. If you can hear any sand-like particles moving inside the float, replace it.
Cover Screws
&
Washers
(Remaining
3 Of 4)
Westerbeke Generators
Pin
90
Roat Retaining Hook
Roat Pivot
Arm
Wire Retaining
Loop
Needle Valve
Seat
Pivot
Carburetor
Top Cover