Westerbeke 7.0 KW BGC -60Hz Technical Manual page 153

This tool allows a mechanic to safely remove the generator end from the engine by attaching this Gener-
ator End Lifting Eye to the four screw holes located under the control panel. To use this Lifting Eye,
remove the generator's control panel and screw the Lifting Eye to the generator end.
I"
5
n
Center lifting eye
on baseplate and
weld securely.
This tool allows a mechanic to safely remove and install the generator drive disks by aligning the disks
with the Drive Plate Guide Pin. The Pin screws into the flywheel and acts as a guide. Also, the pin helps
to support some of the rotor and drive plate's weight while removing or replacing these parts.
IIIIJ!IIIII~"'IIIIIIIIIIIIIIIIIII
Material: One M8 bolt with the hex head machined off and a screw driver slot cut in the machined end.
149 Westerbeke Generators