Westerbeke 7.0 KW BGC -60Hz Technical Manual page 110

10. Assemble the oil pump ay and rear oil seal
retainer.
Tightening Torque
Rear Oil Seal Retainer: 7.2 - 11.6 ft-Ib
(1.0 - 1.6 kg-m)
Oil PumpAy:
11. Assemble the oil strainer.
Tightening Torque
Bolt, Nut:
12. Install the filter.
11.3 - 16.9 ft-Ib
(1.56 - 2.34 kg-m)
4.62 - 6.93 ft-lb
(0.64 - 0.96 kg-m)
13. Check the flange section of the oil pan. If it's
deformed, make it flat by tapping it slightly with
a hammer.
14. Install the oil pan S/A. Thoroughly remove any
foreign matter (grease, water and seal packing)
from the oil pan flange surface. Then, apply
new FIPG to the flange surface and assemble
the oil pan subassembly. Be sure to apply FIPG
in such a way that the FIPG sealing may be
formed, without any discontinued spot, in a size
equivalent to 3 mm to 4 mm diameter, following
the procedure given in the figure.
NOTE: Be sure to assemble the oil pan within
fifteen minutes after the application of the
FIPG. If more than fifteen minutes should
elapse, remove the FIPG and apply the FIPG
again. Then, assemble the oil pan. Also, do
not perform rigorous driving (high load driv-
ing) within three hours after the assembling
of the oil pan.
NOTE: No harmful effect will be made even
if the excess FIPG is oozed out from the
applied sections.
Westerbeke Generators
106
®
About6.5mm
A-A
(Apply the
FIPG
at the corner sections and
sections between bolt holes, following
the above-specified dimensions.)
3 About2mm'
~
____
o~ ~_,
\ 0
//I(se!ion between
bolt holes)
,(@
Apply APG straight with a
Wid~
o
~'.
J
of 6.Smm, without following
I
~
'-~.
- - - - - . 0
the comer.
IlJ
o B B
c
45
Apply
FIPG
15 straight
Apply FIPG with a
slight curvature