Westerbeke 7.0 KW BGC -60Hz Technical Manual page 119

f. Rotate the crankshaft two turns in the normal direc-
tion and stop the crankshaft again at the top dead
center. Make sure that the relationship between
the timing belt and pulleys is correct
g. Install the timing pulley outer flange and timing belt
cover No.1.
Tightening Torque: 3.2 - 4.8 ft-lb
(0.44 - 0.66 kg-m)
7. Install the following parts to the right side of the
engine:
a. The oil filter.
b. The exhaust manifold with related hoses.
8. Install the distributor.
a. Turn the crankshaft and camshaft in such a way
that the No.1 cylinder may be set to the top dead
center on the compression stroke. At this time, the
slit at the rear end of the camshaft is off center to
the right side when viewed from the engine's rear
side.
b. Align the cutout section of the distributor coupling
with the cutout section at the main body.
c. Apply engine oil to the "0" ring and the forward end
section of the shaft. Then, proceed to insert them
into place.
115
Convex side
Slit is off center 1mm
to right side
Cylinder head viewed from rear side
Cut out section at the
main body
Cut out section
of coupling
Westerbeke Generators