1. Loosen the flame arrester's
clamp and remove the arrester
followed by the clamp.
2. Disconnect the fuel supply line,
fuel solenoid wire, electric
choke wire, and the throttle con-
trollinkage (not shown).
3. Remove the two nuts and
washers that secure the car-
buretor to the intake manifold.
Lift the carburetor from the in-
take manifold.
4. Remove the electric choke's
stabilizing screw and the indi-
cated (one
of
four) cover screw
and washer.
Remove the
electric choke.
5. Replace the choke lever spring,
if necessary.
Flame Arrester Clamp
-_~.II'
Carburetor Top Cover
Ball Joint
(To Throttle
Control Unkage)
Fuel Solenoid Wire
Cover Screw
Stabilizing Screw
89
Vacuum Hose
Electric
: Choke
Wire
Westerbeke Generators