Seagull Models 540 Assembly Manual page 9

EDGE 540.
Servo arm.
2) Locate the two nylon control horns, two
nylon control horn backplates and two ma-
chine screws.
2mm x 30 mm.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
Mounting Screws.
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
5 Mount the control horns by inserting the
)
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
6) Thread one nylon adjustable control horn
onto each aileron control rod. Thread the
horns on until they are flush with the ends of
the control rods.
Straigh line.
Control Horn.
Mounting Plate.
Instruction Manual.
7) Pushrod assemble as same as pictures
below:
2.8cm.
M3 lock nut.
Pushrod.
9