Seagull Models 540 Assembly Manual page 12

EDGE 540.
125mm.
2) Place your engine onto the engine
mount. Adjust the engine is centered of the
edges of the engine case.
3) When you are satisfied with the align-
ment, mark the locations of the engine
mounting.
4) Remove the engine. Using an drill bit,
drill the mounting holes through the engine
mount at the four locations marked.
4.2mm
(4 pcs).
5) Bolt the engine to the engine mount
using the four machine screws. Double cheek
that all the screws are tight before proceeding.
6) Attach the Z-Bend in the pushrod wire
to the throttle arm on the carburetor. You will
need to remove the throttle arm from the car-
buretor to be able to attach the Z-bend. When
complete, reattach the throttle arm to the car-
buretor.
12
Instruction Manual.
4mm X 30mm.
WHEEL AND WHEEL PANTS.
1) Assemble and mounting the wheel pants
as shown in the following pictures.
Pushrod wire.