Dtot (Time-Out Timer); D Lock-Out; D Scan Resume Timer; D Scan Restart - Icom IC-41W Instruction Manual

4
SET MODE
D TOT (Time-Out Timer)
The time-out timer limits the length of one continuous trans-
mission. This helps conserve battery charge in the event of
accidental continuous transmission. By default, this is turned
OFF.
TOT OFF (default)

D Lock-out

This allows the user to select the temporary transmission in-
hibit capability, preventing communication overlap, which can
lead to missed or broken transmissions.
• RP (Repeater Lockout): Transmission is permitted only
• BU (Busy Lockout)
• OF (OFF)
Lockout OFF (default)
14
TOT ON
while receiving a matched CTCSS
tone or when no signal is received.
: Transmission is inhibited while re-
ceiving a signal.
: No restrictions.
Repeater lockout setting
D Scan Resume Timer
The scan resume condition can be set as a pause (P5) or
timer scan (15/10/5). When a signal disappears, scanning will
resume after 5 seconds, regardless of the setting.
15/10/5 : Scan pauses for 15/10 or 5 seconds when a signal
is detected, then resumes.
P5 : Scan pauses until the signal disappears, and then
resumes after 5 seconds.
Scan resume timer
P5 (default)
D Scan Restart
When in scan mode, the scan restart function resumes scan-
ning 10 seconds after a transmission has been performed.
Scan restart timer
OFF (default)

D Roger Beep

The roger beep emits a sound as acknowledgement that the
transmission has ceased.
Roger beep OFF (default)
10 sec. setting
Scan restart timer ON
Roger beep ON