Icom IC-41W Instruction Manual page 4

PRECAUTIONS
BE CAREFUL!
for dust-tight and waterproof protection. However, once the
transceiver has been dropped, dust-tight and waterproof pro-
tection cannot be guaranteed because of possible damage to
the transceiver's case or the waterproof seal.
* Only when the jack cover or the optional HM-168LWP is
attached.
Even when the transceiver power is OFF, a slight current still
flows in the circuits. Remove the battery pack or batteries from
the trans ceiver when not using it for a long time. Otherwise,
the installed battery pack or batteries will become exhausted,
and will need to be recharged or replaced.
MAKE SURE
connect ing the supplied/optional equipment.
iii
(Continued)
The IC-41W meets IP67* requirements
to turn the transceiver power OFF before
This device complies with Standard Aus-
tralia Specification No. AS/NZS 4365-2002
and AS/NZS 4295: 2004.