Impex MWM 1800 Owner's Manual page 19

STEP 12 (See Diagram 12)
A.) Now move the machine to its final position. After installing the weight stack, it will be too
heavy to move.
B.) Install 9 Weight Plates (#26) to each set of Guide Rods. To install the plate, lift up the
Selector Rod in the center, hold the plate at an angle and place between the two Guide
Rods (#16) then drop it down. NOTE: Make sure the groves on the plastic covers all face the
same direction. The caps should interlock with each other.
C.) Align the center holes on all plates. Insert the Selector Rod (#24) into the center holes on the
plates. Insert the Weight Selector Pin (#38) into the selected stack of Weight Plates (#26) to
obtain the desired weight for exercise. Make sure the magnet on the Pin faces up. It is
strongly recommended to spray lubricant such as WD-40 on the two Guide Rods to minimize
friction.
D.) Attach the Backrest Board (#30) to the Left Vertical Beam (#17). Secure it with two M8 x 2
1/8" Allen Bolts (#76) and
E.) Attach the Seat Pad (#29) to the Left Seat Support (#14). Secure it with two M8 x 2 1/8"
Allen Bolts (#76) and
F.) Attach the Arm Curl Pad (#31) to the Arm Curl Stand (#21). Secure it with two M8 x 5/8"
Allen Bolts (#75) and
on the Left Seat Support (#14). Secure it with a Lock Knob (#84).
5/8" Washers (#49).
5/8" Washers (#49).
5/8" Washers (#49). Insert the Arm Curl Stand into the top opening
18
DIAGRAM 12