Impex MWM 1800 Owner's Manual page 17

STEP 11 (See Diagram 11)
A.) Attach the 39" Ab Cable (#35) to the opening on the Left Vertical Beam (#17). Attach
a Pulley to the opening. Secure the Pulley with one M10 x 2 ½" Allen Bolt (#69), two
7/8 x ½" Pulley Bushings (#61), and one M10 Aircraft Nut (#81).
B.) Pull the Ab Cable around the Pulley then downward. Attach the end of Cable to a
Chain (#65). Secure the Cable to the Chain with one M10 x 1" Allen Bolt (#67), two
¾" Washers (#50), and one M10 Aircraft Nut (#81). Let the Chain hanging for now.
C.) Attach the 171" Lower Cable (#33) to the opening on the Leg Developer (#13). Attach
a Pulley to the opening. Secure it with one M10 x 2 ½" Allen Bolt (#69), two
½" Pulley Bushings (#61), and one M10 Aircraft Nut (#81). Draw the Lower Cable
underneath the Pulley through the opening on the Left Seat Support (#14) then to the
open bracket on the Left Base Frame (#15).
D.) Attach a Pulley to the bracket. Secure it with one M10 x 2" Allen Bolt (#68), two
Washers (#50), and one M10 Aircraft Nut (#81).
E.) Draw the Lower Cable (#33) underneath the Pulley along the Left Base Frame and
through the opening on the Left Vertical Frame to the second open bracket on the Left
Base Frame. Attach an L-shaped Bracket (#89) to the bracket then repeat the step D
above to install a Pulley.
F.) Pull the Cable underneath the Pulley then upward to the Double Floating Pulley
Bracket (#87) previously installed. Repeat the step D above to install a Pulley.
G.) Draw the Cable around the Pulley then pull the Cable downward to the first Bracket
on the Left Base Frame (#15). Install another Pulley.
H.) Pull the Cable around the Pulley then upward to the Chain (#65). Connect the Cable
end to the Chain using a C-clip (#39).
I.) Check the tightness of the Cable loop. If the cable loop is too loose, shorten the
chain.
16
7/8" x
¾"