Albatron P4M800 Pro User Manual page 47

Place the boot floppy disk (from the "Preparation and Setup" section) into the floppy drive and turn on
your system.
Note: If your system is not setup to use the floppy drive as the first boot drive, you must enter the BIOS
setup utility and make the appropriate adjustments. During the initial boot up sequence the screen will
display a message that will give you an opportunity to enter the BIOS setup utility (typically, "Press
Delete Key to enter BIOS utility") .
Once in the BIOS Utility, follow this path: Advanced -> Hard Disk Boot Priority -> First Boot Device and
set the "First Boot Device" to "Removable".
After the system boots from the floppy, the system will enter into the DOS mode (Note that the system
has booted using the ABS card's BIOS).
6. With the system still running, you must carefully
move the jumper cap on the ABS Card (ABS_JP1
header) back to its "Onboard
disables the ABS BIOS which will now allow you to
flash the corrupted mainboard BIOS from the floppy
disk.
7. At the DOS prompt, type "DIR" and take notice of the name of the BIOS file name which ends with the
extension ".bin" (e.g. K8N7003.bin"). There should also be an AWDFLASH.exe file present. Then type:
awdflash(space)(the file name of .bin).bin (For example: awdflash(space) k8n7003.bin)
BIOS" position. This
Type "dir", press
ENTER
Note the file name
of .bin
Type "awdflash(space)
xxxx.bin", press ENTER
43
Closed
("Closed" means putting a jumper cap
onto two adjacent header pins.)