Albatron P4M800 Pro User Manual page 50

11. After you have recovered your onboard BIOS, you can choose to remove or not remove the ABS
Card from the mainboard.
If you do choose to remove the ABS Card from the mainboard, make sure that the system is powered off
before you remove the card. After you remove the ABS card you must replace the two jumper caps on
the BIOSCN1 header back to the default positions (pins 1-2 and pins 3-4 are both closed as shown).
If you choose not remove the ABS Card from the mainboard, make sure that the jumper caps on the
ABS_JP1 header located on the ABS Card to the
damage opportunity of the rescue BIOS in ABS Card and on the other hand to extend the usage life of
the ABS Card.
Attention
If both your onboard BIOS and rescue BIOS are damaged
unfortunately, the ABS Card will fail the feature of providing BIOS
backup. Therefore, it is recommended that recover the onboard BIOS in
advance, and take the ABS Card as emergency happen.
"Onboard
Closed
("Closed" means putting a jumper cap
onto two adjacent header pins.)
46
BIOS" as below, in order to reduce the