Connectors - Albatron P4M800 Pro User Manual

Audio Ports: Sound
This mainboard provides three Audio Ports. The Mic-in, Line-in and
Line-out are standard audio ports that provide basic audio function.
Line-In (Blue) This port is used to attach an external audio device such
as a CD player, tape player or other audio device that has an audio input
connector. When the Super 5.1 Channel Audio Effect is enabled, your
rear speakers will be enabled with this port.
Line-Out (Green) It is a standard audio port and used to attach speaker
or headset. When the Super 5.1 Channel Audio Effect is enabled, your front speakers will be enabled
with this port. In addition, if you have enabled the Super 5.1 Channel Audio Effect but still are using the
Standard 2-channel audio play, we strongly recommend you to use this port.
Mic-In (Pink) This port is used to attach a microphone to input your voice. When the Super 5.1 Channel
Audio Effect is enabled, your subwoofer/center equipments will be enabled.
.

Connectors

Floppy Disk Drive Connector: FDC
The mainboard provides a standard floppy disk drive connector (FDC) that supports to be attached
maximal two 360Kb/ 720Kb/ 1.2Mb/ 1.44Mb/ 2.88Mb floppy disk drives by FDD ribbon cables.
Hard disk drive Connectors: IDE1/2, SATA1/2
The mainboard provides two IDE connectors with Ultra ATA 66/100/133 specification. You can maximal
attach four IDE devices, such as hard disk drive (HDD), CD-ROM, DVD-ROM, and so on by IDE ribbon
cables. The onboard Serial ATA, two SATA connectors support the transfer rate up to 1.5 Gbps.
Primary IDE Connector: IDE1
There are two maximal IDE devices can attach to one IDE connector. If you attach two IDE HDDs, you
must use a ribbon cable which with two cable connectors. You also must configure one drive as the
master and the other one as the slave.
Secondary IDE Connector: IDE2
The IDE2 connector can also be attached with two HDDs by IDE ribbon cable; however, you also must
configure one as the Master and the other one as the Slave.
SATA Connector: SATA1/2
The two SATA connectors support a transfer rate of 1.5 Gbps. One SATA connector only can attach one
SATA HDD of each time.
This mainboard supports Super 5.1 Channel Audio Effect which you
can transfer the audio system from 2-channel to 6-channel. See
Appendix I for more information.
10