Table of Contents
Advertisement
4.2.5.2 Point-to-Point Configuration
When the board is set to not register with a SIP server (see
intercom to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The Intercom can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 4-15. SIP Configuration Page Set to Point-to-Point Mode
Intercom is set to NOT register with a SiP server
930242L
Installing the VoIP Intercom
Figure
4-15), it's possible to set the
CyberData Corporation
32
Intercom Setup
Advertisement
Table of Contents
Need help?
Do you have a question about the 010935F and is the answer not in the manual?
Questions and answers