Table of Contents
Advertisement
4
Installing the Software
Refer to the Microsoft Windows NT documentation and online Help
for more information on installing drivers and software application
programs, and configuring your computer's video display.
Install the Intense 3D Video Display Driver
To install the Intense 3D video display driver:
1. Insert the first diskette containing the Intense 3D video display
driver into the computer's floppy disk drive.
CAUTION
Make sure you have the correct driver to use with the Windows NT
4.0 operating system. If you are unsure, refer to the
file on the driver diskette for this information.
2. Log on to Windows NT using an account that has administrative
privileges.
3. Create a directory on the computer's hard disk, and copy the
contents of the Intense 3D video driver diskettes to that directory.
4. From the operating system Start menu, go to Settings/Control
Panel/Display/Settings.
5. Click Display Type, and then click Change.
6. In the Change Display dialog, click Have Disk.
7. In the Install From Disk dialog, enter the pathname of the
directory you created in step 3, and click OK.
8. Verify that the Intergraph Intense 3D driver is highlighted in the
Change Display dialog, and click OK.
9. Click Yes when asked if you want to install a third-party driver.
The driver files are copied from the diskette to your computer's
primary hard disk drive.
10. After the driver files are successfully copied, a message that the
driver successfully installed displays. Click OK.
11. Click Close to exit the Display Type dialog.
12. Click Close to exit the Display Properties dialog.
13. When informed that the computer must be restarted for the new
settings to take effect, remove the diskette from the computer's
floppy disk drive and click Yes to restart the computer.
11
.
README
TXT
Advertisement
Table of Contents
Need help?
Do you have a question about the Intense 3D Pro 3400 and is the answer not in the manual?
Questions and answers