Installing Wildcat Driver Software; Make Sure The Computer Is Ready; Remove Existing Wildcat Driver Software - Intergraph Intense3D Wildcat 4210 User Manual

NOTE If the computer's monitors do not have built-in video cables, use shielded video
cables. The cables should have DVI-I connectors or 15-pin VGA connectors (with
adapters) at one end for the video output port on the card, and the appropriate
connectors at the other end for the video input ports on the monitors. See the
documentation delivered with the computer's monitors for more information.
NOTE If you installed the Wildcat 4210 video card, the computer will boot into VGA mode.
Go to "Installing Wildcat Driver Software" for instructions on installing the Wildcat
driver software.

Installing Wildcat Driver Software

If you are installing or replacing a Wildcat 4210 card or reinstalling Wildcat driver software, take
the following steps.
Refer to the Microsoft Windows NT or Windows 2000 documentation and online Help for more
information on installing driver software.

Make Sure the Computer is Ready

Make sure the computer has the following before installing the Wildcat driver software:
Microsoft Windows 2000 or Microsoft Windows NT Workstation 4.0 with Service Pack 5 (or
later)
3 MB of free space on the computer's primary system disk
CAUTION You must have the correct driver for Windows 2000 or Windows NT 4.0. If you are
unsure, refer to the

Remove Existing Wildcat Driver Software

If you are reinstalling Wildcat driver software, you must first remove the currently installed
Wildcat driver software.
To remove Wildcat driver software in Windows 2000:
1. Log on to Windows 2000 using an account that has administrative privileges.
2. From the operating system Start menu, go to Settings » Control Panel » Add/Remove
Programs » Change and Remove Programs.
3. Highlight the Intense3D Display Driver and click Change/Remove.
4. Click Yes when prompted to confirm driver software removal and follow the prompts.
5. Click OK when notified that driver software removal is complete.
6. Restart the computer.
file on the driver CD or diskette for this information.
README
9