Installing The Software; Install The Intense 3D Pro 2200S Video Display Driver - Intergraph Intense 3D Pro 2200S Installation Manual

4

Installing the Software

Refer to the Microsoft Windows NT documentation and online Help for
more information on installing drivers and software application
programs, and configuring your computer's video display.
Install the Intense 3D Pro 2200S Video
Display Driver
To install the Intense 3D Pro 2200S video display driver:
1. Insert the diskette containing the video display driver into the
computer's floppy disk drive.
CAUTION Make sure you have the correct driver to use with the Windows NT
4.0 operating system. If you are unsure, refer to the
file on the driver diskette for this information.
2. Log on to Windows NT using an account that has administrative
privileges.
3. In the Windows NT Control Panel, open Display to view the
Display Properties dialog.
4. Click Settings (tab), then click Display Type, and then click
Change. The Change Display dialog displays.
5. Click Have Disk. The Install From Disk dialog displays.
6. Type the driver path name (for example, a:\ ), and then click OK.
7. Verify that the Intergraph Intense 3D driver is highlighted in the
Change Display dialog, and then click OK.
8. Click Yes when asked if you want to install a third-party driver.
The driver files are copied from the diskette to your computer's
primary hard disk drive.
9. After the driver files are successfully copied, a message that the
driver successfully installed displays. Click OK.
10. Click Close to exit the Display Type dialog.
11. Click Close to exit the Display Properties dialog.
12. When informed that the computer must be restarted for the new
settings to take effect, remove the diskette from the computer's
floppy disk drive and click Yes to restart the computer.
13
.
README TXT