Installing The Software; Install The Intense 3D Pro Driver - Intergraph Intense 3D Pro 1000 Installation Manual

4

Installing the Software

Refer to the Microsoft Windows NT documentation and online Help
for more information on installing drivers and software application
programs, and configuring your computer's video display.

Install the Intense 3D Pro Driver

To install the Intense 3D Pro driver:
1. Insert the diskette containing the Intense 3D Pro driver into the
computer's floppy disk drive.
CAUTION Make sure you have the correct driver for the operating system
running on your computer (Windows NT 3.51 or Windows NT 4.0).
If you are unsure, refer to the
for this information.
2. Log on to Windows NT using an account that has administrative
privileges.
3. In the Windows NT Control Panel, open Display to view the
Display Properties dialog (Windows NT 4.0) or the Display
Settings dialog (Windows NT 3.51).
4. In Windows NT 4.0, select the Settings tab, then select Display
Type, and then select Change.
In Windows NT 3.51, select Change Display Type.
5. Follow the instructions in the dialogs to change adapter type and
install the video display driver. You will install the driver from a
manufacturer-supplied diskette in the computer's floppy disk drive
(usually referred to as drive A).
6. When the Video Configuration (Windows NT 3.51) or Display
(Windows NT 4.0) dialog displays, configure the video display.
Refer to the online Help available from the dialogs for more
information. When finished, select OK.
7. When informed that the computer must be restarted for the new
settings to take effect, remove the diskette from the floppy disk
drive and restart the computer.
For more detailed installation information, refer to the
file delivered on the diskette containing the Intense 3D Pro driver.
. file on the driver diskette
README TXT
9
.
README TXT