Table of Contents
Advertisement
I
I
I
I
I
I
I
I
I
When Scanning Does not Start
If sefalnmg does not start, check the following
Item to check
Is the power on~
the SCSI ID set properly?
Am the DIP swrtches set properly~
Are the SCSI cables connected securey'~
Are the indicators on or flash=ng?
Action
Turn on the power
, If there are any other SCSI devices
I connected, the host computer may not be
able to reeogmze the scanner ff it has the
, same SCSI ID as another devtce Refer to
P 11, "Semng the SCSI ID," and set a
umque SCSI ID for the scanner
:The correct DIP switch settings depend on
whether tbas scanner is the last device m the
!SCSI dmsy chain Refer to P ll,
' "Connecting the SCSI Cable," and set the
DIP sw~tches properly
; If any cables are dmconnected, connect
them.
The nature of an error can be determined
according to the pattern m wluch the four
mchcators are on or flashing Refer to P28,
'T_xror Indacators and Soluuons"
Is the scanner dnver selected properly?
For detads on scanner driver setup, refer to
the manual or help mformatton for your
scanner driver
Are the software settings correct?
For detatls on software settings, refer to the
' manual or help reformation for your
software
I
!
I
27
Advertisement
Table of Contents
