Sett, Ng The Scsi Id; Connecting The Scsi Cable (No Connectton To Other Port); I Connecting To The Host Computer - Bell and Howell 2000 FB User Manual

2000 fb scanner

Hide thumbs Also See for 2000 FB:

Table of Contents

~]l~[tlmport~nt

The total length of the SCSI cables, in-

cluding the length of the cable reside

the personal computer, should be no

more than 3m (9 8 ft ) when using syn-

chronous transfer, and no more than 6m

(19 7 ft ) when using asynchronous

transfer

Some combinations of SCSI boards and

peripheral devices that are connected

stmultaneously may not work together

properly

Setting the SCSl ID

i] Torn the rotary switch to set the SCSI

ID number.

Note

If you change the setting while the

power is on, it Is necessary to nnuahze

the scanner Refer to P 16, "Imuahz-

mg the Scanner"

Connecting to the Host Computer

Connecting the SCSl Cable

(No Connection

to Other Port)

Turn off the host computer and all

peripheral devices that will be con-

nected through the SCSI interface.

Use SCSI cables to connect the per-

sonal computer and the peripheral de-

vices in dmsy chain fashion, w~h this

scanner at the end of the daisy chain.

(Use either of the two $CSI connec-

tors on the scanner.)

~ Set DIP switch 3 to off.

Tins enables the scanner's internal termi-

nator For detads on the funcUons of the

DIP switches, refer to P43, "DIP

Sw~tches"

Table of Contents