Loading Media For Printing From An External Supply - Intermec PX4i User Manual

Chapter 1 — Using the Printer

Loading Media for Printing From an External Supply

42
You can place the media supply, such as fanfold tickets or tags, behind
the printer. The external supply can be used with these printing
methods:
• Tear-off (straight-through)
• Cut-off
Peel-off (upper slot only)
•
• Internal batch takeup
Intermec strongly recommends using the fanfold guide accessory.
This guide makes loading media easier and accurately guides the
media. The fanfold guide can be adjusted for various media widths
down to 40 mm (1.57 in).
Note: Make sure to protect the media from dust, dirt, or other foreign
particles that can impair the printout quality or cause unnecessary
wear to the printhead.
To load media for printing from an external supply
1 (Optional) Fit the fanfold guides in either the upper or lower slot.
The outer guide is adjustable for various media widths. The
minimum width is 40 mm (1.58 in).
• Fit the fanfold guide into the upper slot in the rear plate when
the supply is at the same level as the printer or in peel-off
mode.
• Fit the fanfold guide into the lower slot in the rear plate when
the supply is placed lower than the printer.
PX4i and PX6i High Performance Printer User's Manual