Intermec PX4i User Manual page 125

Fingerprint Error Messages (continued)
Message Description
RtW off by This condition is set by the Fingerprint SYSHEALTH
application command. For more information, see the
Fingerprint Command Reference
If you perform a user break by pressing S - P to
Application
break stop an application from running, or if a runtime
error occurs, the Intermec Ready-to-Work indicator
turns off. You can turn the indicator on by changing
to Direct Protocol or running an application.
But, if the application handles the break (ON
BREAK) or runtime error (ON ERROR GOTO), the
Intermec Ready-to-Work indicator is not affected,
and the application sets the status. For more
information, see the
Reference
Printhead not Printhead not found.
found
Rebooted The printer has been rebooted.
Initializing The printer is initializing.
Printer crash Printer crash. In most instances, when the printer
crashes, the screen is reset which causes the Intermec
Ready-to-Work indicator to turn off.
Printer turned The printer is off.
off
Maintenance Maintenance
Power supply The power supply is overheated and needs to cool
Over down.
temperature
Printhead too The printhead is overheated and needs to cool down.
hot You need to resend your print job.
PX4i and PX6i High Performance Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
Intermec Fingerprint Command
Manual.
Intermec
Manual.
Ready-to-Work Error
Indicator Status Number
Off
Off
Off
Off
Off
Off
Off
Off
Off 1718
Off 1088
111