Intermec PX4i User Manual page 137

PX4i and PX6i High Performance Printer User's Manual
Chapter 4 — Troubleshooting and Maintaining the Printer
To test the LSS
1 Make sure that your printer is properly configured for the type of
media you are using. Go to SETUP > MEDIA > MEDIA TYPE.
2 Open the media cover.
3 Lift and lower the printhead.
A
4 Press the button.
5 Make sure there is a label (not a gap or mark) at the LSS.
6 Make sure that the media is routed as close to the center section as
the guide allows.
7 Press T to enter the Setup menu, and use the keypad to go to the
LSS menu:
• If you are running Fingerprint, go to SETUP > PRINT DEFS >
LSS TEST > LSS AUTO.
• If you are running IPL, go to SETUP > TEST/SERVICE > LSS
TEST > LSS AUTO.
The screen displays the LSS AUTO menu with the cursor in the
center.
LSS AUTO
Note: There is no way to adjust the LSS function; the menus
only indicate values obtained from the LSS. The test menu can
determine if the sensor unit is not physically in position, is blocked
by dust or stuck labels, or is defective in some way.
8 Check gap detection:
a Lift the printhead.
b Slowly pull out the media. When the LSS detects a gap or
detection slot, the cursor moves to the right.
LSS AUTO
9 Check mark detection:
123