Ipl Error Messages - Intermec PX4i User Manual

Chapter 4 — Troubleshooting and Maintaining the Printer

IPL Error Messages

Message Description
Paper Out The printer is out of paper. Load a new roll of media.
For help, see
Ribbon Out The printer is out of transfer ribbon. Load a new roll
of ribbon. For helps, see
page
Ribbon Fitted This is not an error condition. This message briefly
appears after a new roll of transfer ribbon is
installed.
Printhead Up The printhead is lifted. Lower the printhead.
Open & Shut Cutter error 1. Open and shut the cutter.
Cutter
Open & Shut Cutter error 2. Open and shut the cutter.
Cutter
Open & Shut Cutter error 3. Open and shut the cutter.
Cutter
Paper Fault LSS too high. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see
Paper Fault LSS too low. This error can occur when you run a
test feed without any media installed, or if you have
incorrect media settings. Load the printer with
media and select the appropriate media type. For
help, see
Paper Fault The printer did not perform a test feed before it
printed out test labels. Performing a test feed
calibrates the sensor.
To perform a testfeed
Press the A button.
•
Press the F button to resume.
Press Feed
Paused This is not an error condition. This message appears
when the print job is paused.
Setup mode entered.
IP link error. No network connection.
112
"Loading Media" on page
"Loading Ribbon" on
44.
"Loading Media" on page
"Loading Media" on page
PX4i and PX6i High Performance Printer User's Manual
Ready-to-Work
Indicator Status
Blinking
8.
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
Blinking
8.
Blinking
8.
Blinking
Blinking
Blinking
Off
Blinking
Error
Number
1005
1031
1027
1058
1022
1059
1701