Loading Media For Cut-Off Operation; Loading An Media From An External Supply - Intermec PF8d User Manual

Loading Media for Cut-Off Operation

Loading an Media from an External Supply

PF8d/PF8t Printers User's Guide
The cutter (optional accessory) cannot be used to cut through
labels, only through the liner between the labels. Cutting
through the labels will cause the adhesive to stick to cutting
parts and prevent the cutter from working properly. Media
rolls must be wound with the printable side facing upward to
prevent jamming the cutter.
To load cut-off media
1 Press the release buttons on both sides of the case to open the
top cover. Fold the cover upwards/rearwards.
2 Pull or lift the spindle and remove the empty label roll core (if
present).
Note: The PF8t spindle lifts completely out of the spindle
compartment while the PF8d spindle lifts up but remains
attached to the printer.
3 Insert the spindle into the core of a fresh media roll. Rotate
the spindle to fit the inside diameter of the core (see the core
diameter markings on the spindle).
4 Put the label between the label guides and pull it forward.
5 Adjust the label guide to fit the media you are using.
6 Route the media through the slot in the optional cutter
mechanism just in front of the tear bar.
7 Close the top cover.
Note: If you are loading media for the first time or changing
from another type or size of media, perform a label gap sensor
adjustment as described on page 34.
Insert the media through the slot in the back of the printer.
Follow the instructions for the type of media you are using. The
spindle is not used when using an external media supply.
Note: Be careful to protect an external media supply from dirt,
grit, dust, water, and direct sunlight.
Chapter 2 — Installing the Printer
23