Appendix D Sip Ip Phone Parameter - Cisco 7960G Administration Manual

Table D-1
Parameter
autocomplete
call_hold_ringback
call_managerx_addr
call_managerx_sip_port
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
D-2
Configuration File Parameters (continued)
Description
(Phone-specific; optional) Configures automatic completion of
numbers being dialed.
Valid values are:
•
•
•
•
Default is 1.
(Phone-specific; optional) If you have a call on hold and are talking
on another call, when you hang up the call, this parameter causes the
phone to ring, letting you know that you still have another party on
hold.
Valid values are as follows:
•
•
•
•
Default is 0.
Reserved.
Reserved.
0—The autocomplete feature is disabled by default but can be
turned on (or off) using the phone interface.
1—The autocomplete feature is enabled by default but can be
turned off (or on) using the phone interface.
2—The autocomplete feature is disabled and cannot be turned
on (or off) using the phone interface. To set this parameter for
a specific phone, configure it in that phone's configuration file.
3—The autocomplete feature is enabled and cannot be turned
off (or on) using the phone interface. To set this parameter for
a specific phone, configure it in that phone's configuration file.
0—Off by default, but can be turned on and off locally using the
user interface.
1—On by default, but can be turned on and off locally using the
user interface.
2—Off permanently and cannot be turned on and off locally
using the user interface. Specify this parameter in the
phone-specific configuration file.
3—On permanently and cannot be turned on and off locally
using the user interface. Specify this parameter in the
phone-specific configuration file.
Appendix D SIP IP Phone Parameters
OL-7890-01