Cisco 7960G Administration Manual page 75

Chapter 5 Monitoring Cisco SIP IP Phones
Table 5-1 CLI Commands (continued)
Command
show command keywords (continued)
OL-7890-01
Purpose
flash—Flash memory information.
•
dspstate—DSP status, including whether the DSP is
•
ready, the audio mode, whether keepalive pending is
turned on, and the ringer state.
rtp—Packet statistics for the RTP streams.
•
tcp—Status of TCP ports, including the state (listen or
•
closed) and the port number.
lsm—Current status of the Line State Manager control
•
blocks.
• fsm—Current status of the Feature State Manager
function control blocks.
fsmdef—Current status of the Default Feature State
•
Manager data control blocks.
• fsmcnf—Current status of the Conference Feature State
Manager call control blocks.
• fsmxfr—Current status of the Transfer Feature State
Manager transfer control blocks.
• fim—Current status of the Feature Interaction Manager
control blocks (interface control blocks and state control
blocks).
gsm—Global State Manager status that includes these
•
parameters: vcm, lsm, fim, fsm, and gsm.
register—Current registration status of SIP lines.
•
• reset-log—Debugging information about the internal
state of the phone at the time that it was last restarted.
• network—Network information, such as phone platform,
DHCP server, phone IP address and subnet mask, default
gateway, address of the TFTP server, phone MAC
address, domain name, and phone name.
config—Current flash memory configuration, including
•
network information, phone label and password, SNTP
server address, DST information, time and date format,
and input and output port numbers.
personaldir—Current contents of the personal directory.
•
This command can be used only if the telnet_level
parameter is set to allow privileged commands to be
executed.
• dialplan—Phone dial plan.
• timers—Current status of the platform timers.
(Optional) running—Shows the running configuration.
•
all—Shows all.
•
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
How to Use the Command-Line Interface to Monitor Phones
5-5