Cisco 7960G Administration Manual page 169

Appendix D SIP IP Phone Parameters
Table D-1
Parameter
nat_received_processing
network_media_type
network_port2_type
outbound_proxy
OL-7890-01
Configuration File Parameters (continued)
Description
(Optional) Enables NAT received processing.
Valid values are 0 (disable) and 1 (enable). Default is 0.
If nat_received_processing is enabled, and the received= tag is in
the Via header of the 200 OK response from a REGISTER, the IP
address in the received= tag is used instead of the nat_address in the
Contact header. If this switch occurs, the phone unregisters the old
IP address and reregisters with the new IP address.
(Optional) Ethernet port negotiation mode.
Valid values are as follows:
•
•
•
•
•
Default is Auto.
(Optional) Configures the device type that is connected to port 2 of
the phone.
Valid values are Hub/Switch and PC. Default is Hub/Switch.
Note
(Optional) IP address of the outbound proxy server. You can use
either a dotted IP address or a DNS name.
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
Auto—Port is autonegotiated.
Full100—Port is configured to be a full-duplex, 100-MB
connection.
Half100—Port is configured to be a half-duplex, 100-MB
connection.
Full10—Port is configured to be a full-duplex, 10-MB
connection.
Half10—Port is configured to be a half-duplex, 10-MB
connection.
If the value is PC, port 2 can be connected only to a PC. If
you are not sure about the connection, use the Hub/Switch
default value. Specifying the PC option and then connecting
port 2 to a switch results in spanning-tree loops and network
confusion.
D-11