Chapter 5 Monitoring Cisco Sip Ip Phones; How To Use The Command-Line Interface To Monitor Phones - Cisco 7960G Administration Manual

Monitoring Cisco SIP IP Phones
This chapter provides information on the following:
•
•

How to Use the Command-Line Interface to Monitor Phones

You can use Telnet or a console to connect to your Cisco Unified IP Phone 7960G and 7940G, and you
can and use the command-line interface (CLI) to debug or troubleshoot the phone.
available CLI commands and their syntax.
Note •
•
•
Table 5-1
OL-7890-01
How to Use the Command-Line Interface to Monitor Phones, page 5-1
How to Use the Phone Menus to Access Status Information, page 5-18
You need the phone IP address to use the CLI in a Telnet session. To get the IP address, select
Settings > Network Configuration > IP Address. The default Telnet password is "cisco."
You can conduct only two Telnet sessions at any time.
The phone cannot originate a Telnet session to another address.
describes the available commands.
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
C H A P T E R
Table 5-1
5
shows the
5-1