Cisco 7960G Administration Manual page 175

Appendix D SIP IP Phone Parameters
Table D-1
Parameter
xml_card_dir
xml_card_file
Table D-2
Parameter
Admin.VLAN Id
Alternate TFTP
Default Router 1 to 5
DHCP Address Released
OL-7890-01
Configuration File Parameters (continued)
Description
Reserved.
Reserved.
Network Parameters
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
Description
Unique identifier of the VLAN to which the phone
is attached, for use in switched networks that are
not Cisco networks.
If you have an administrative VLAN
Note
setting assigned on the Catalyst switch,
that setting overrides any changes made
on the phone.
Whether to use an alternate remote TFTP server
rather than the local one.
Valid values are Yes and No. If you set this
parameter to Yes, you must change the IP address
in the TFTP Server parameter to the address of the
alternate TFTP server. Default is No.
IP address (1) of the default gateway used by the
phone and (2 to 5) of the gateways that the phone
attempts to use as an alternate gateway if the
default gateway is unavailable.
Note Default Router 1 always takes
precedence. If Router 1 is unavailable, the
phone moves down the list of available
routers in order based on the configuration
in Routers 2 through 5.
If you have an administrative VLAN
Note
setting assigned on the Catalyst switch,
that setting overrides any changes made
on the phone.
Whether the IP address of the phone can be
released for reuse in the network.
Valid values are Yes and No. When set to Yes, the
phone sends a DHCP release message to the
DHCP server and goes into a release state. The
release state provides enough time to remove the
phone from the network before the phone attempts
to acquire another IP address from the DHCP
server. When you move the phone to a new
network segment, first release the DHCP address.
D-17