Cisco 7960G Administration Manual page 171

Appendix D SIP IP Phone Parameters
Table D-1
Parameter
proxy_register
proxyx_address
proxyx_port
remote_party_id
OL-7890-01
Configuration File Parameters (continued)
Description
(Optional) The phone must register with a proxy server during
initialization.
Valid values are 0 (disable registration during initialization) and 1
(enable registration during initialization). Default is 0.
Note
Note
IP address of the SIP proxy servers that are used by the phones.
Enter the addresses in IP dotted-decimal notation or use the FQDN.
The "x" argument is representative of server addresses.
Valid values for "x" are 1 to 6. If the proxyx_address parameter is
provisioned with an FQDN, the phone sends REGISTER and
INVITE messages by using the FQDN in the Req-URI, To, and
From fields.
If the value of x is not specified in the proxyx_address parameter,
the phone uses proxy1_address as the default value.
Port number of the SIP proxy server that will be used by phone lines
other than line 1. The x variable represents a phone line.
Valid values are 2 to 6.
Note
(Optional) The Remote-Party-ID header supports network
verification and screening of a call participant's identity (for
example, name and number) and provides privacy for call
participants.
Valid values are as follows:
•
•
Default is 0.
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
You can also use this parameter in a phone-specific
configuration file. After a phone has initialized and
registered with a proxy server, you can remove the
registration by changing this value to 0 in the phone-specific
configuration file. To reinitiate registration, change the
value back to 1.
If you enable registration and authentication is required,
you must specify values for the linex_authname and
linex_password parameters in the phone-specific
configuration file.
For additional phone lines, the proxyx_port parameter and
the proxyx_port parameter can be used to assign different
proxy addresses to different phone lines. The "x" in the
parameters represents a phone line. The value of "x" can be
from 1 to 6. If the value of the "x" is not specified in the
proxyx_address parameter, the phone uses proxy1_address
as the default.
0—Remote party ID is disabled. The phone does not send or
accept the remote party ID.
1—Remote party ID is enabled. The phone sends the remote
party ID, and can accept the remote party ID.
D-13