Prepare For Parts Replacement; Parts Replacement Time Has Passed; Unknown File; Calibration There Is A Problem With The Multi-Sensor - Canon imagePROGRAF iPF9400S User Manual

iPF9400S

Prepare for parts replacement.

Prepare for parts replacement.
Cause
It is almost time to replace consumables for
which service is required.

Parts replacement time has passed.

Parts replacement time has passed.
It is past the recommended time to replace consumables for which service is required.

Unknown file.

Unknown file.
Cause
Data sent to keep the printer up to date (such as paper
information) is in the wrong format.
You have uploaded firmware for a different model.

Calibration There is a problem with the multi-sensor.

Calibration There is a problem with the multi-sensor.
Cause
The performance of a sensor inside the printer may be im-
paired.

Multi-sensor error

Multi-sensor error
Cause
Direct sunlight or strong lighting may be shining on the
printer and causing the sensor to malfunction.
The performance of a sensor inside the printer may be
impaired.
User's Guide
If "Parts replacement time has passed." is displayed, you can continue to use the printer for
some time.
Contact your Canon dealer for assistance.
Cause
Check the data. Turn off the printer and wait a while before restoring power, and
then resend the data.
Check the firmware version. Turn off the printer and wait a while before restoring
power, and then resend the firmware.
If the message is displayed again, contact your Canon dealer for assistance.
Press the OK button and cancel calibration. Contact your Canon dealer for assis-
tance.
Take steps to ensure the printer is not used when exposed to direct sunlight or
strong lighting.
Turn off the printer and wait at least three seconds before restoring the power.
If the message is displayed again, contact your Canon dealer for assistance.
Prepare for parts replacement.
Corrective Action
Corrective Action
Contact your Canon dealer for assistance.
Corrective Action
Corrective Action
Corrective Action
939