Configuring The Vcs As A Traversal Server; Overview; Adding A New Traversal Server Zone; D14049.04 - TANDBERG VCS Administrator's Manual

Grey Headline (continued)

Configuring the VCS as a Traversal Server

Overview

The VCS Expressway can act as a firewall
traversal server. This feature means you can:
•
Allow your VCS to act as a traversal server
for other VCSs and TANDBERG Gatekeepers.
You do this by adding a new traversal server
zone on the VCS, and configuring it with
details of the traversal client.
•
Provide firewall traversal for any traversal-
enabled endpoints (i.e. TANDBERG MXP
endpoints and any other endpoints that
support the ITU H.460.18 and H.460.19
standards) registered directly with it. You
can configure the protocols and ports that
will be used.
•
Enable and configure STUN services.
•
Configure the ports used specifically for
firewall traversal services.
The following sections describe how to
configure each of the above options.
Overview and
Introduction Getting Started
Status

D14049.04

JULY 2008
•
VCS Configuration > Zones .
You will be taken to the Zones page.
Select New.
You will be taken to the Create Zone page.
•
xCommand ZoneAd d
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones.
Type
From the Type drop-down menu, select
TraversalServer.
Create Zone
Click here to create the zone. You will be taken
directly to the Edit Zone page, where you can
configure the traversal server zone as required.
System VCS Zones and
Configuration Configuration Neighbors

Adding a New Traversal Server Zone

Call Bandwidth
Processing Control
158
TANDBERG VIDEO COMMUNICATIONS SERVER
Firewall
Applications Maintenance
Traversal
ADMINISTRATOR GUIDE
Appendices