Table of Contents
Advertisement
Grey Headline (continued)
Upgrading Software
(Continued from previous page)
You must restart the system after you
!
have uploaded the new software
version and confirmed the upgrade, in
order for the installation to complete. Any
configuration changes you make between
confirming the upgrade and restarting will be
lost, so we recommend restarting your system
immediately.
Before you start the upgrade, ensure
that the software image file for the new
version has been saved in a network
location that can be accessed via the web
interface. Also ensure that you have the
16-character Release Key readily available (this
is not required if you are upgrading to a dot
release, e.g. X3.0 to X3.1).
Overview and
Introduction
Getting Started
Status
D14049.04
JULY 2008
Upgrading via the Web Interface (cont.)
System
VCS
Zones and
Configuration
Configuration
Neighbors
Call
Bandwidth
Processing
Control
179
TANDBERG
VIDEO COMMUNICATIONS SERVER
Software upgrade in progress
This screen appears while the new version of
software is being copied to your system.
Software successfully upgraded
This screen indicates that the software has
been copied to your system successfully.
You will need to restart the VCS in order for
the new version to take effect. Restarting
will cause all current calls to terminate, and
all current registrations to be ended. This
page indicates the number of active calls and
registrations on your VCS so that you can
restart it at an appropriate time.
If you do not restart the system
immediately, you should refresh this
page before restarting to check the
current status of calls and registrations.
Restart system
Click here after checking the active calls and
registrations to ensure that it is an appropriate
time to restart the VCS.
The system will restart and after a few minutes
you will be taken to the Login screen.
The upgrade is now complete.
Firewall
Applications
Maintenance
Traversal
ADMINISTRATOR GUIDE
Appendices
Advertisement
Table of Contents
