Configuring H.323 - TANDBERG VCS Administrator's Manual

Grey Headline (continued)
H.323
To configure the VCS's H.323 settings:
•
VCS Configuration > Protocols > H.323
You will be taken to the H.323 page.
•
xConfiguration H32 3
H.323 Mode
Determines whether or not the VCS will provide
H.323 gatekeeper functionality.
Registration UDP port
Specifies the port to be used for H.323 UDP
registrations.
The default is 1719.
Call signaling TCP port
Specifies the port that listens for H.323 call
signaling.
The default is 1720.
Call signaling port range start
Specifies the lower port in the range to be used
by H.323 calls once they are established.
The default is 15000.
Call signaling port range end
Specifies the upper port in the range to be
used by H.323 calls once they are established.
The default is 19999.
The call signalling port range must be
!
great enough to support all the
required concurrent calls.
Overview and
Introduction Getting Started
Status
D14049.04
JULY 2008
.
System VCS
Configuration Configuration

Configuring H.323

Zones and Call Bandwidth
Neighbors Processing Control
66
TANDBERG VIDEO COMMUNICATIONS SERVER
Registration conflict mode
Determines how the system will behave if an
endpoint attempts to register an alias currently
registered from another IP address.
Reject: denies the registration.
Overwrite: deletes the original registration and
replaces it with the new registration.
The default is Reject.
Time to live
Specifies the interval (in seconds) at which an
H.323 endpoint must re-register with the VCS
in order to confirm that it is still functioning.
The default is 1800.
Call time to live
Specifies the interval (in seconds) at which the
VCS polls the endpoints in a call to verify that
they are still in the call
The default is 120.
Auto discover
Determines whether or not the VCS responds
to gatekeeper discovery requests from
endpoints.
The default is On.
Save
Click here to save your changes.
Firewall
Applications Maintenance
Traversal
ADMINISTRATOR GUIDE
Appendices