Table of Contents
Advertisement
2. With the engine running, apply the parking
brake once and release the brake pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold
the transmitter (SmartStart™ uses only the
SmartStart™ icon).
The parking lights will flash 3 times quickly
and remain lit. Release the button.
Remove the key: the engine will keep on running.
4.
Exit the vehicle. All doors should be closed, including the hood and trunk.
5.
THERE ARE THREE POSSIBLE OPTIONS TO COMPLETE READY MODE (programmable
6.
by installer)
OPTION 1: Automatic shut
down without auto lock
The engine runs for 8 sec.
before finally shutting down
the engine, without user
interaction.
WARNING: The vehicle is
not armed or locked down.
7. The Parking lights will flash twice and the
mode is set. If the icon doesn't appear, refresh the screen by pressing
Remote Starting
1.
Press the
2.
The remote will beep once and the LCD will display "START".
3.
The remote will confirm the remote starter's activation by beeping 3 times.
If your vehicle has an automatic transmission and it does not start at the first attempt, the system
will shut down, wait a few seconds and try to start the engine again. There will be 3 start attempts
before the system gives up.
Driving Off
With the vehicle running remotely, press the
installed) and unlock the doors. Enter the vehicle and do the following:
1.
Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
2.
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
User Guide
,
or
on
OPTION 2: Manual shut down
(default)
The engine keeps going until you
press either;
a.
to lock the doors and shut
down the engine;
b.
to unlock the doors and
shut down the engine;
c.
to shut down the engine
without affecting the doors.
WARNING: Engine runs until the
pre-programmed
expires.
button for approximately 1 second and release.
2. With the engine running, apply the parking
brake twice within 10 sec.
3. Make sure to release the brake pedal.
The parking lights will flash 3 times quickly
and remain lit.
The engine runs for 8 sec.
then locks the doors before
finally shutting down the
engine,
interaction.
WARNING: Do not leave
run
time
your keys in the vehicle!
icon will appear on screen to indicate Ready
button to disarm the system and the starter kill (if
OPTION 3: Automatic shut
down with auto lock
without
.
user
P.11
Advertisement
Table of Contents
