Extended Run Time; Intrusion Codes Via Led Light; Car Finder - Directed Electronics PS-7870TWE-FM User Manual

Smart start two-way lcd automatic/manual transmission remote starter with full alarm system
Hide thumbs Also See for PS-7870TWE-FM:
Table of Contents

Advertisement

• Start the engine remotely.
• Turn the ignition key to the IGNITION ON (RUN) position.
• Or by using the remote as so:
2-way remote
Through advance function remote's menu (page-6), select L-01.
Press and hold the
1-way remote
a. Rapidly press AUX twice. While the remote's LED is flashing, press and hold
parking lights flash for 2 seconds, pause, and then flash once.
To verify whether the system is in cold weather mode:
The
icon should appear on your remote display.
OR
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal
is pressed. (Automatic transmission ONLY)
Extended Run Time 
While the vehicle is running remotely, press and hold the
This will reset the run time counter to zero and restart the run time cycle from the beginning
Note: The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press and release the
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle has
been running for 2 minutes already, pressing the
the engine to run for another cycle (in this case, 3 minutes).
Intrusion Codes via LED light 
The system monitors the following:
Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
Doors
Ignition
Trunk
Hood
Note: If an intrusion has occurred, the siren will sound for a maximum of 60 seconds.
When an intrusion has occurred, pressing
LED will provide an intrusion code corresponding to the type of the intrusion that occurred. The
LED intrusion codes are flashed in continuous loops.
2x = Doors intrusion
3x = Shock Sense
4x = Hood
Car Finder™ 
When enabled, the Car Finder™ option will help you locate your vehicle by sounding a siren or the
horn. To initiate,
1.
Through advance function remote's menu (page-6), select L-01.
2.
Press
User Guide
button until the
to sound the siren once without affecting the door.
icon will disappear on the display.
button until the remote beeps 3 times.
button will reset the counter to zero and allow
will make the siren chirps four times. The antenna's
5x = Panic
6x = Ignition
7x = Trunk
button.
until the
P.17

Advertisement

Table of Contents
loading

Table of Contents