Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
T W O - W A Y L C D A U T O M A T I C / M A N U A L
T R A N S M I S S I O N R E M O T E S T A R T E R W I T H F U L L
A L A R M S Y S T E M
PS-7870TWE-FM
Once the battery is weak, the LCD remote will display a battery low voltage icon
and an "L-BAT" indication with 2 beeps to warn the user to charge it.
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 100827
Rev:1.5
User Guide
It is the responsibility of the vehicle operators to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Battery Low Voltage Warning
Designed & engineered in Canada
© 2010
WARNING!
-PS-7870TWE-FM-
-FcN-
Canada
Advertisement
Table of Contents
Related Manuals for Directed Electronics PS-7870TWE-FM
Summary of Contents for Directed Electronics PS-7870TWE-FM
-
Page 1: User Guide
T R A N S M I S S I O N R E M O T E S T A R T E R W I T H F U L L A L A R M S Y S T E M PS-7870TWE-FM User Guide... -
Page 2: Table Of Contents
Table of Contents GOVERNMENT REGULATIONS ..............................4 INTRODUCTION ................................4 VEHICLE PRESETS ................................... 5 ....................................5 EATER & H ..........................5 INDSHIELD IPERS ADIO EADLIGHTS USING THE TRANSMITTER ............................... 5 LCD R ................................. 5 EMOTE UNCTIONS ... - Page 3 What is EncryptR™ Technology? EncryptR™ employs proprietary encryption software that sends unique codes from the remote starter to the ADS-TB or ADS-AL-CA bypass module that cannot be replicated or reversed with hi-tech equipment. The EncryptR™ communication exchanged between the remote starter and the ADS bypass module is best described as a “secret handshake”...
-
Page 4: Government Regulations
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. -
Page 5: Vehicle Presets
Vehicle Presets Heater When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan) should not be left on . It is recommended HIGH to leave the settings on instead. -
Page 6: Lcd Transmitter Basic Confirmations
Side view: Function Button: -Turns ON the backlight -Allows access to Multi- level functions -Enters Programming mode Charger port: the battery charger plugs into this port. CAUTION!! DO NOT USE A CHARGER OTHER THAN THE ONE SUPPLIED. LCD Transmitter basic confirmations Function Button pressed Icon / text Sound Instructions / description... -
Page 7: Charging The Battery
Press the for at least 1 second and release. The backlight should turn ON. Within 3seconds, press the button for 2 seconds to access the various functions. Charging the Battery • Plug in the USB charger. CAUTION!! DO NOT USE A CHARGER OTHER THAN THE ONE SUPPLIED. •... - Page 8 Remote’s advanced functions and MENU table: Display Description Parking meter countdown This version of the countdown feature is particularly useful for keeping track of parking meter time: the user may quickly set up the countdown using the Parking . The transmitter will beep 6 times, 5min before the Parking countdown reaches Menu 0 and beeps 6 times once the countdown expires.
- Page 9 Through Advanced Options, first press to select MENU, then: Choose TSTART and press Set the time at which you want to remote start the vehicle. First set the hour, and press . Then set the minutes and press Choose ON and wait. A flashing “T” and will appear on the screen to confirm activation.
-
Page 10: Remote Starting Your Vehicle
(13) If there is no activity within the programmed time, the keypad will automatically lock after 5 seconds, 10 seconds or 20 seconds. Press for about 1sec to unlock the transmitter’s keypad. • LCD illumination: ILLUM When this function is enabled, the LCD will illuminate each time Lock, Unlock or (14) START is activated. -
Page 11: Remote Starting
• to lock the doors and shut down the engine; • to unlock the doors and shut down the engine; • to shut down the engine without affecting the doors. 8. The icon will appear on your screen. Remote Starting Press the button for approximately 1 second and release. -
Page 12: Intrusion Alert Via Remote
Intrusion alert via remote The remote will beep or vibrate for about 60 seconds when an intrusion from door, hood, trunk, shock or ignition is detected. At the same time, the LCD remote will display “ ” and “ ALARM DOOR / real time” (depending on the type of alarm) alternately. The icons of door, HOOD / TRUNK / SHOCK / hood, trunk and shock, as well as the red backlight, will be flashing (when the is set... -
Page 13: Idle Mode
Idle Mode Convenience feature: Idle Mode allows you to keep the engine running and the doors locked while you stop, for example, at a convenience store or for a short delivery. (remove this part for IG) This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the Ignition Switch) while the engine is running. - Page 14 Press the buttons simultaneously until the icon appears on your LCD remote. The LED on the antenna will come ON solid to indicate that the vehicle has successfully entered Combo valet. To put the system into Combo Valet mode using the PUSH BUTTON SWITCH: Insert the ignition key into the ignition switch.
-
Page 15: Panic Mode
Once the selection is done, press Choose ON or OFF, then press and hold until; (1) The icon appears or disappears to confirm Combo Valet is enabled or disabled. (2) The icon appears or disappears to confirm Valet start is enabled or disabled. -
Page 16: Extended Run Time
Extended Run Time While the vehicle is running under a remote start, press and hold the button for more than 3 seconds until the remote beeps 3 times. This will reset the run time counter to zero and restart the run time cycle from the beginning. The extended run time procedure can only be carried out once per remote start. -
Page 17: Relock
Relock If you unlock the doors with the remote transmitter, but do not open any door, hood, trunk or turn ignition within 30 seconds, the system will automatically relock and arm. Note: When the system is in active arming mode and the relock mode is enabled, the doors will relock but the system will not rearm. -
Page 18: Home Valet Tm " Mode
To keep your vehicle protected when the factory security system is disarmed for a remote start, Secure Lock will relock your doors as soon as the vehicle is started. Once the engine is shut down by remote or after its runtime has expired, Secure Lock will also rearm your factory security system and relock the doors. -
Page 19: Siren Chirps
Remove the ignition key from the ignition switch. The engine will continue running. Exit the vehicle and close all doors, hood and trunk. Press the button; this will lock the doors, arm the system alarm and confirm that the vehicle is in Turbo Mode. The engine will shut down after 60 seconds. -
Page 20: Shock Sense & Warn Away Sense
• Active arming with disarm notification: This feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or when the Module is disarmed after being previously armed, the opening or closing of a Door will cause the Horn or the Siren to sound once after 10 sec. -
Page 21: Multi-Level Features (Default State)
MultiLevel Features (default state) The multi-level features allow you to access different features of your vehicle or of a second car by pressing the button once, twice or three times. For convenience purpose, the order of LEVELS and MENU can be re-arranged through FBPRO setting (page-7). Features: •... -
Page 22: Troubleshooting Transmitting Range
Troubleshooting Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) • Metal: any type of metal will affect operating range. This includes the vehicle itself. •...