Signaling Protocol Identifier; Site-Specific Option Number Setting - Avaya one-X Installation And Maintenance Manual

Signaling Protocol Identifier

Use the following procedure to set or change the Signaling Protocol Identifier. A valid SIG
Protocol Identifier is either 0 (default), 1 (H.323), or 2 (SIP).
Note:
Perform this procedure only if the LAN Administrator instructs you to do so.
Note:
1. When you select SIG... from the Admin Procedures Screen, the telephone prompts you to
use the Right and Left navigation arrows to select a setting and displays the following text:
Setting: text string
where the text string is the wording associated with the current system value of SIG,
defined as:
"Default" when SIG = 0
●
"H.323" when SIG = 1
●
"SIP" when SIG = 2
●
2. To change the setting, press Change until you see the setting you want or use the Right (or
Left) navigation arrow to cycle through the settings.
Depending on the current value, the next sequential text string is selected and displayed as
the setting. For example, if the current value is SIP (2), pressing the Right arrow changes
the value to 0 (default). If the current value is H.323 (1), pressing Right arrow changes the
value to 2 (SIP).
3. Press Save to store the new setting and redisplay the Admin Procedures screen.
The remainder of this procedure depends on the status of the boot and application files.
For information, see

Site-Specific Option Number Setting

!
CAUTION:
Do not perform this procedure if you are using static addressing. Perform this
CAUTION:
procedure only if you are using DHCP and the LAN administrator instructs you to
do this.
Choice Selector
Appendix A: Restart Scenarios.
Signaling Protocol Identifier
Issue 1 May 2007 37