Axis A1001 User Manual page 50

AXIS A1001 Network Door Controller & AXIS Entry Manager
Technical Specifications
Function
0 V DC (-)
Input
Auxiliary Connector
4-pin configurable I/O terminal block for:
• Auxiliary power (DC output)
• Digital Input
• Digital Output
• 0 V DC (-)
For an example connection diagram, see Connection Diagrams, on page 52.
Function
0 V DC (-)
DC output
Configurable
(Input or Output)
Power Connector
2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant
limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output
current limited to ≤5 A.
When used in systems that require UL certification, the product shall be powered by a UL
294-listed or UL 603-listed Class 2 low-voltage power limited power supply.
Function
0 V DC (-)
DC input
Network Connector
RJ45 Ethernet connector. Supports Power over Ethernet (PoE).
When used in systems that require UL certification, the product shall be connected to UL
294B-listed network equipment.
Pin Notes
1, 3
2, 4
For communicating with door monitor.
Digital input — Connect to pin 1 or 3 respectively to
activate, or leave floating (unconnected) to deactivate.
Note: This pin can only be used for input.
Pin Notes
1
2
For powering auxiliary equipment.
Note: This pin can only be used as power out.
3–4
Digital input — Connect to pin 1 to activate, or leave
floating (unconnected) to deactivate.
Digital output — Connect to pin 1 to activate, or leave
floating (unconnected) to deactivate. If used with an
inductive load, e.g. a relay, a diode must be connected
in parallel with the load, for protection against voltage
transients.
Pin Notes
1
2 For powering controller when not using Power over
Ethernet.
Note: This pin can only be used as power in.
50
Specifications
0 V DC
0 to max 40 V DC
Specifications
0 V DC
3.3 V DC
Max load = 100 mA
0 to max 40 V DC
0 to max 40 V DC, open drain,
100 mA
Specifications
0 V DC
10–30 V DC, max 26 W,
Max load on outputs = 14 W