Axis A1001 User Manual page 31

AXIS A1001 Network Door Controller & AXIS Entry Manager
Alarm and Event Configuration
Readers have different LED behaviors, but typically they use different sequences of steady lights and flashing lights in red, green, and
amber.
Readers can also use one-pitch beepers to send messages, using different sequences of short and long beeper signals.
The table below shows the events that are preconfigured in the door controller to trigger reader feedback and their typical reader
feedback signals.
Event
Idle
RequirePIN
AccessGranted
AccessDenied
Feedback messages other than the above must be configured by a client such as an access management system, through the VAPIX®
application programming interface, that supports this feature and use readers that can provide the required signals. For more
information, see the user information supplied by the access management system developer and reader manufacturer.
Dual LED or OSDP Single LED
Red
Off
Blinking
Red/Green
Green On
Red Off
Beeper pattern
Silent
Two short beeps
One short beep
One long beep
31
State
Normal
PIN required
Access granted
Access denied