Changing The Remote Escape Character - Multitech MultiModem DID MT5634ZBA-DID User Manual

MultiModemDID User Guide

Changing the Remote Escape Character

To increase security, you can change a remote modem's remote configuration escape character. The re-
mote configuration escape character is stored in register S9 . The factory default is 37, which is the ASCII
code for the percent character (%). Setting S9 to 0 (zero) disables remote configuration entirely—but if
you do this remotely, you won't be able to change it back remotely!
1. Establish a remote configuration link with the remote modem as described in "Basic Procedure."
2. Type ATS9= n , where n is the ASCII code for the new remote configuration escape character, then
press ENTER.
3. Save the new value by typing AT&W and pressing ENTER.
4. Type ATO<CR> to exit remote configuration.
Chapter 5 - Remote Configuration
42