Multitech MultiModem DID MT5634ZBA-DID User Manual page 21

Data/fax/did modem
Hide thumbs Also See for MultiModem DID MT5634ZBA-DID:
Table of Contents

Advertisement

MultiModemDID User Guide
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Note: You can also set the inactivity timer by changing the value of S30.
Command:
Values:
Default:
Description:
Command:
Values:
Defaults:
Description:
Command:
Values:
Defaults:
Description:
Chapter 4 - AT Commands, S-Registers, Result Codes
\N n
Error Correction Mode Selection
n = 0–5, or 7
3
\N0
Non-error correction mode with data buffering (buffer mode;
same as &Q6).
\N1
Direct mode.
\N2
MNP reliable mode. If the modem cannot make an MNP
connection, it disconnects.
\N3
V.42/MNP auto-reliable mode. The modem attempts first to
connect in V.42 error correction mode, then in MNP mode, and
finally in non-error-correction (buffer) mode with continued
operation.
\N4
V.42 reliable mode. If the modem cannot make a V.42
connection, it disconnects.
\N5
V.42, MNP, or non-error correction (same as \N3).
\N7
V.42, MNP, or non-error correction (same as \N3).
\Q n
Flow Control Selection
n = 0, 1, or 3
3
\Q0
Disables flow control (same as &K0).
\Q1
XON/XOFF software flow control (same as &K4).
\Q2
CTS-only flow control. Not supported.
\Q3
RTS/CTS hardware flow control (same as &K3).
\T n
Inactivity Timer
n = 0, 1–255
0
\Tn
Sets the time (in minutes) that the modem waits after the last
character is sent or received before it disconnects. A value of
zero disables the timer. Applies only in buffer mode.
\V n
Protocol Result Code
n = 0, 1, or 2
1
\V0
Disables the appending of the protocol result code to the DCE
speed.
\V1
Enables the appending of the protocol result code to the DCE
speed.
\V2
Same as \V1.
\X n
XON/XOFF Pass-Through
n = 0 or 1
0
\X0
Modem responds to and discards XON/XOFF characters.
\X1
Modem responds to and passes XON/XOFF characters.
-C n
Data Calling Tone
n = 0 or 1
0
-C0
Disables V.25 data calling tone to deny remote data/fax/voice
discrimination.
-C1
Enables V.25 data calling tone to allow remote data/fax/voice
discrimination.
21

Advertisement

Table of Contents
loading

Table of Contents