Multitech MultiModem DID MT5634ZBA-DID User Manual page 23

MultiModemDID User Guide
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description:
Command:
Values:
Default:
Description: $SB300
Command: +DCS= x,y Select V.44 Data Compression
Values:
Default:
Description:
Chapter 4 - AT Commands, S-Registers, Result Codes
%R n Cisco Configuration
n = 0, 1
0
%R0 Disables Cisco configuration.
%R1 Sets E0, Q1, &D0, \N0, $SB9600, and %S1 for operation with
a Cisco router.
%S n Command Speed Response
n = 0, 1
0
%S0 Sets modem to respond to AT commands at all normal speeds.
%S1 AT commands accepted at 115200 bps only. AT commands at
other speeds are ignored.
$D n DTR Dialing
n = 0 or 1
0
$D0 Disables DTR dialing.
$D1 Dials the number in memory location 0 when DTR goes high.
$EB n Asynchronous Word Length
n = 0 or 1
0
$EB0 Enables 10-bit mode.
$EB1 Enables 11-bit mode.
$SB n Serial Port Baud Rate
n = speed in bits per second
57600
Set serial port to 300 bps.
$SB1200 Set serial port to 1200 bps.
$SB2400 Set serial port to 2400 bps.
$SB4800 Set serial port to 4800 bps.
$SB9600 Set serial port to 9600 bps.
$SB19200 Set serial port to 19200 bps.
$SB38400 Set serial port to 38400 bps.
$SB57600 Set serial port to 57600 bps.
$SB115200 Set serial port to 115200 bps.
x = 0 or 1 (V.42 bis )
y = 0, 1, or 2 (V.44)
1, 2
Selects V.42bis/V.44 data compression.
+DCS=0,0 V.42bis and V.44 data compression are both disabled.
+DCS=0,1 V.42bis is disabled; V.44 data compression is acceptable.
+DCS=0,2 V.42bis is disabled; V.44 only when connected to a V.92
server.
+DCS=1,0 V.42bis is acceptable; V.44 data compression is disabled.
+DCS=1,1 V.42bis is acceptable; V.44 data compression is acceptable.
+DCS=1,2 V.42bis is acceptable; V.44 only when connected to a V.92 server.
+DCS=? Displays the allowed values.
+DCS? Displays the current value.
23